Differences

This shows you the differences between two versions of the page.

--- namespace:cameras [2026/02/06 16:46] – created admin
+++ namespace:cameras [2026/05/19 23:57] (current) – [Baslers] admin
@@ Line 6: / Line 6: @@
 Connections:
-  * Unordered List Item
+  * External Trigger: Camera gets an Input to know when to start the acquisition
+  * Output A, B, C: Camera send an output to other devices to trigger their timing
+  * Fire: Camera sends a signal to show the duration of the Exposure Time
+  * Arm: Camera sends a signal indicating when it can accept an External Trigger
+  * Direct Gate: Camera gets a signal, that times the opening and closing of the PhotoCathode Gate
+  * Gate Monitor: Camera sends a signal showing when the PhotoCathode was intensified(Cable is supplied by Andor)
+Internal Configurations:
+  * Acquisition Mode: Single
+  * Triggering: External
+  * Readout Mode: Image
+  * Exposure Time: 1ms
+  * Vert Pixel Shift: Speed 6.5, Voltage: Normal
+  * Horiz Pixel Shift: Rate 3MHz, Pre Amp Gain 4x
+  * Gate Mode: DDG
+  * Gain: 1500+(with ND Filters)
+  * Insertion Delay: Ultra Fast (about 19ns)
+  * Optical Width: ON
+  * Gater: Delay about 99.99us, Width as low as 1.65ns
+==== Baslers====
+Basler_4/Frodo
+{{https://docs.baslerweb.com/a2a3840-45umbas|Basler_4/Frodo Manual}}
+{{https://docs.baslerweb.com/aca1300-200um|Basler_1/EnergyCam}}
+====Streak Camera====
+Here are the steps to continuously triggering the streak camera and allowing the python script to archive the images.
+  - Turn on the camera and the HV
+  - Click on ''File'', then Click ''Algorithms\AcquireLoop.ini''
+  - the click to ''Algorithms Tab'', then navigate the directory from ''Algorithms to Loop: N=1''
+  - Click the "PLAY" button to run.
+  - Move to a terminal, Go to Directory:
+  - Run
+  - If you do a test, while Gen Archiving, from your laptop, the Shot_Numbers should match
+{{:namespace:img_1116.jpeg?400|}}\\
+{{:namespace:img_1114.jpeg?400|}}\\
+{{:namespace:img_1117.jpeg?400|}}\\